Montana CDL Permit Test Exam Prep
Free practice questions

Free MT-CDL Practice Questions

10 exam-style questions with answers and explanations, straight from our 1,030-question bank. Tap an answer to check yourself. When you're ready, take the scored version in the free practice test.

Start the free practice test → ★★★★★4.9/5 from 2,400+ candidates · No signup

These 10 free MT-CDL questions are organized by exam domain, so you can see how each part of the Montana CDL Permit Test blueprint is tested. Reveal the answer and explanation under each question.

Domain 1: General Knowledge

Question 1

At 60 mph, the left steering tire on a loaded tractor-semitrailer suddenly blows and the vehicle pulls left. Which immediate action best preserves control?

Show answer & explanation

Correct answer: D - Hold the steering wheel firmly and stay off the brakes until control is stabilized

Question 2

On a dry highway, a driver is operating a 70-foot combination at 55 mph. Under the standard CDL following-distance rule, what minimum time gap should the driver maintain?

Show answer & explanation

Correct answer: A - 8 seconds

Question 3

A 14,000-pound machine on a flatbed is secured with tie-downs whose combined working load limit is 6,000 pounds. The number of tie-downs and anchor locations are otherwise adequate. What must be done before departure?

Show answer & explanation

Correct answer: C - Add securement until the aggregate working load limit reaches at least 7,000 pounds

Domain 2: Air Brakes

Question 4

During a static air-leakage test on a fully charged tractor-semitrailer, the engine is off, the parking brakes are released, and the service brake is not applied. After the gauges stabilize, pressure drops 2 psi in one minute. How should this result be judged?

Show answer & explanation

Correct answer: B - Pass; the loss is less than 3 psi in one minute

Domain 3: Combination Vehicles

Question 5

A tug test holds after a tractor couples to a semitrailer. The visual inspection, however, shows a gap between the upper plate and fifth wheel, with the locking jaws around the kingpin head rather than its shank. What is the proper response?

Show answer & explanation

Correct answer: C - Uncouple and recouple until there is no gap and the jaws surround the kingpin shank

Domain 4: Tank Vehicles

Question 6

A passenger bus approaches a railroad crossing under a green highway traffic signal. Traffic beyond the tracks is stopped, leaving enough room for only half the bus. What should the driver do?

Show answer & explanation

Correct answer: D - Remain before the crossing until the entire bus can clear the tracks

Domain 5: Passenger Transport

Question 7

After coupling a set of doubles, air reaches the first trailer but the rear trailer will not charge. Inspection finds the shutoff valves at the rear of both trailers closed. Which valve arrangement is correct for travel?

Show answer & explanation

Correct answer: A - Open the first trailer's rear shutoff valves and keep the last trailer's rear valves closed

Domain 6: Doubles and Triples

Question 8

A half-full baffled cargo tank is approaching a sharp exit ramp. Which fact should have the greatest influence on the driver's speed choice?

Show answer & explanation

Correct answer: C - Baffles reduce forward-and-back surge, but side-to-side surge can still roll the tank

Domain 7: Hazardous Materials

Question 9

A shipping clerk prepares a hazardous-material description for gasoline in Packing Group II. Which sequence places the four basic description elements in the required order?

Show answer & explanation

Correct answer: B - UN1203, Gasoline, 3, PG II

Domain 8: School Bus

Question 10

A Montana school-bus driver activates the amber warning lamps 200 feet before an approved rural stop outside a city or town. What correction is needed on the next run?

Show answer & explanation

Correct answer: A - Begin the amber warning about 500 feet before the stop

That's 10 of 1,030

The full bank has 1,020 more MT-CDL questions with explanations.

Continue in the free practice test →

View plans